-
In order to find out stack fault of a three input nand
gate how many necessary input vectors are needed ?
-
What is parity generation ?
-
A nand gate becomes ___ gate when used with negative
logic ?
-
What is the advantage of cmos over nmos ?
-
What is the advantage of synchronous circuits over
asynchronous circuits ?
-
What is the function of ALE in 8085 ?
-
A voice signal sample is stored as one byte. Frequency
range is 16 Hz to 20 Hz. What is the memory size required to store 4 minutes
voice signal?
-
What will the controller do before interrupting CPU?
-
In a normalized floating point representation,
mantissa is represented using 24 bits and exponent with 8 bits using signed
representation. What is range ?
-
The stack uses which policy out of the following--
LIFO, FIFO, Round Robin or none of these ?
-
Where will be the actual address of the subroutine is
placed for vectored interrupts?
-
Give the equivalent Gray code representation of AC2H.
-
What is the memory space required if two unsigned 8
bit numbers are multiplied ?
-
The vector address of RST 7.5 in 8085 processor is
_______.
Ans. 003C (multiply 7.5 by 8 and convert to
hex)
-
Subtract the following hexadecimal numbers--- 8416
- 2A16
-
Add the following BCD numbers--- 1001 and 0100
-
How much time does a serial link of 64 Kbps take to
transmit a picture with 540 pixels
-
Give the output when the input of a D-flip flop is
tied to the output through the XOR gate.
-
How much time does a serial link of 64 Kbps take to
transmit a picture with 540 pixels.
-
Give the output when the input of a D-flip flop is
tied to the output through the XOR gate
Implement the NOR gate as an inverter.
-
What is the effect of temperature on the Icb
in a transistor
-
What is the bit storage capacity of a ROM with a
512*4 organization?
-
What is the reason of the refresh operation in dynamic
RAM's ?
-
Suppose that the D input of a flip flop changes from
low to high in the middle of a clock pulse. Describe what happens if the
flip flop is a positive edge triggered type?
-
How many flip flops are required to produce a divide
by 32 device ?
-
An active HIGH input S-R latch has a 1 on the S input
and a 0 on the R input. What state is the latch in?
-
Implement the logic equation Y = C^BA^ + CB^A + CBA
with a multiplexer.
(where C^ stands for C complement)
-
Equivalent Gray code representation of AC2H.
-
What does a PLL consist of ?
-
The starting location of an array is 1000. If the
array[1..5/...4] is stored in row major order, what is the location of
element [4,3]. Each word occupies 4 bytes
-
In a tertiary tree, which has three childs for every
node, if the number of internal nodes are N, then the total number of leaf
nodes are
-
Explain the term "locality of reference" ?
-
What is the language used for Artificial Intelligence
Ans: lisp
-
What is the character set used in JAVA 2.0 ?
Ans: Unicode
-
char a =0xAA ;
int b ;
b = (int) a ;
b = b >> 4 ;
printf("%x",b);
What is the output of the above program segment
?
-
struct s1 { struct { struct { int x; } s2 } s3 }y;
How does one access x in the above given structure definition ?
-
Why there is no recursion in Fortran ?
Ans. There is no dynamic
allocation.
-
What is the worst case complexity of Quick sort?
Ans. O(n2)
-
What will be sequence of operating system activities
when an interrupt occurs ?